Dual-liquid glue filling machine is an automatic mechanical equipment that can realize automatic mixing and proportioning of two-component glue. Because it can greatly reduce the human input of enterprises and save labor costs for enterprises, it is favored by many manufacturers. Below, let Xiaobian explain to you a few precautions in the use of the double-liquid glue filling machine.

①Some glues are prone to bubbles and affect the quality. Before pouring glue, the glue needs to be deaerated by a vacuum machine to improve the quality of glue pouring.      

2 The glue filling workshop should try to keep the normal temperature of 25 degrees. The temperature has a great influence on the usable time and curing time of the glue. In addition, when the air conditioner is turned on, pay attention that the water mist from the air outlet should not be directly sprinkled on the surface of the glue layer, and avoid mixing with agent B. The chemical reaction of the ingredients, white mist, oily, granular and other phenomena!    

③The glue must be mixed strictly according to the weight ratio. If the B agent is too much, the curing will be accelerated and the glue will be hard, and cracks will easily occur after curing, which cannot achieve a good waterproof effect; if the B agent component is too small, the The slowing down of the curing speed makes the glue soft, and it can't even dry, and it will not dry for a long time!      

④Control the viscosity range of the glue used by the two-liquid glue filling machine, because different metering pumps have requirements on the viscosity. If the requirements of the metering pump are exceeded, the glue will be inaccurate or even unable to work normally.      

⑤There are very few people who will have mild skin allergy and mild itching after prolonged contact with the glue. It is recommended to wear protective gloves when using it. If it sticks to the skin, please wipe it off with acetone or alcohol, and use a detergent to clean it. clean.      

⑥When the glue is poured, the stirring speed should not be too fast or too violent. It should be mixed slowly along the wall of the vessel. Full mixing can make the chemical reaction more sufficient, the fluidity is better, and it is also conducive to better defoaming!      

⑦If the glue used is different each time, be sure to clean the material barrel of the double-liquid glue filling machine first, and clean the pipes and pumps first, otherwise it will cause glue poisoning, resulting in the glue poured out. A lot of bubbles appear, or the glue doesn't cure, etc.! If the same glue is used all the time, and the continuous operation only needs to clean the mixing part. It is recommended to pour glue for the same glue.